Trailing Arm, Upper – OEM Reproduction w/ “Pull” Bushing
For those of you that want the benefits of the “Pull” bushing but without the hassle of installing them.
OEM reproduction stampings with our bushings installed. Sized for use with a 1/2″ bolt. These are a bolt in ready unit.
(Sold Individually)
$130.50
Brackets, Trailing Arm (Single Hole)
Designed for the Wissota street stocks, these trailing arm brackets have the lowest mounting hole position possible. 4.0″ from axle tube to center of hole.
(Sold as a Pair)
$50.40
Axles, Non-Floater 30″, 5×5, (28 or 31 Spline)
These new Superior 28 or 31-spline axles feature screw in studs in a 5×5 wheel bolt pattern, , ¼ thick heavy duty bearing retainer plates, and tapered wheel bearings pressed on.
$325.00
Rear End Brace Kit (Main Bracket Only)
This is the main bracket for the “Rear End Brace Kits” (sold individually)
$18.98
Bushing, “SPHERICAL” – Trailing Arm (MAXIMUM)
MAXIMUM Spherical Bushing
Sold individually
$44.95
Axle, 32″ GN Gun Drilled (31 Spline)
29.5″ Premium GN gun drilled axle.
$199.50
Brackets, Trailing Arm (Multi-Hole)
This trailing arm bracket kit was designed to allow trailing arm angle adjustments just like what can be done on modifieds…..
(Sold as a Pair)
$84.00
Axles, Non-Floater 30″, 5×4 3/4, (31 Spline)
These new Currie 31-spline axles feature press in studs in a 5×4 3/4 wheel bolt pattern, , ¼ thick heavy duty bearing retainer plates, and tapered wheel bearings pressed on.
$325.00
Bushing, “PULL” (Trailing Arms)
This is a new bushing that is used in the upper & lower trailing arms to create side bite and cushioning of the rear end.
Sold individually
$30.75
Rear End Brace Kit – 60″
This kit is design to reinforce the rear end so that the tubes do not bend if a wheel gets wrecked.
It will also prevent the rear end from deflecting under load and changing the alignment of the rear end while braking and under gas.
(USRA Legal)
$119.94
Reviews
There are no reviews yet.