Aluminum Kit, Dash (IMCA/USRA/WISSOTA Stock Car) – Gloss Black (2016-2022)
$325.00
Dash aluminum kit used on IMCA, USRA or WISSOTA stock cars. Gloss Black (2016-2022)
- Description
- Reviews (0)
Description
Dash aluminum kit used on IMCA, USRA or WISSOTA stock cars. Gloss Black (2016-2022)
Be the first to review “Aluminum Kit, Dash (IMCA/USRA/WISSOTA Stock Car) – Gloss Black (2016-2022)” Cancel reply
You may also like…
-
Add to cartQuick View
Aluminum Kit, Interior Wall (IMCA/USRA Stock Car) – Gloss Black (2016-2022)
Interior wall aluminum kit used on IMCA or USRA stock cars. Gloss Black (2016-2022)
Add to cartQuick View -
Add to cartQuick View
Aluminum Kit, Rear Deck (IMCA/USRA/WISSOTA Stock Car) – Gloss Black (2016-2022)
Rear deck and firewall used on IMCA, USRA or WISSOTA stock cars. Gloss Black (2016-2022)
Add to cartQuick View
Related Products
-
Add to cartQuick View
Decal Package
$9.95Add to cartQuick View -
Add to cartQuick View
Plate, Hood Pin Mount
These aluminum hood pins plates are thicker to provide increased durability versus the thin steel ones normally found in kits. Sized for ½ diameter hood pin. (Sold as pair)
Add to cartQuick View -
Add to cartQuick View
QUICKCAR, 2 – 1 Gauge Panel – 5″ Tach- OP/WH BK
QuickCar’s LED backlit Oil Pressure, 5” Tachometer, and Water Temperature standard mechanical gauges mounted in a black panel measuring 11-7/8” wide and 4-1/2” tall. Panel comes complete with all sending units, warning lights, and wiring for easy installation. Water Temp. gauge comes with a 1/2”-NPT adapter to mount in the intake of almost any high-performance engine while Oil Pressure has a standard 1/8”-NPT fitting for plumbing lines (sold separately). Tachometer has a 5” display from 0-10,000 RPM’s with a single high recall and can be used with a 4-cylinder, 6-cylinder, or V8 engine. Warning lights activate when Oil Pressure drops below 20 PSI, Water Temp. goes above 235°F.
Add to cartQuick View -
Add to cartQuick View
QUARTER PANEL-LOWER, 2-PIECE, FABRICATED – LEFT (STOCK CAR)
This fully fabricated rear quarter panels works for most all style stock car bodies. Does have double bend lower monte carlo lines in it, perfect for meshing with our fabricated door panels.
Add to cartQuick View -
Add to cartQuick View
Hinges, Trunk Lid
These brackets are used to mount the hood or trunk lid on all stock bodies.
Sold as a pair.
Add to cartQuick View -
Add to cartQuick View
Shifter – 1– Lever
6061 Aluminum 1 lever shifter specifically designed for circle track racers!
Add to cartQuick View -
Add to cartQuick View
Throttle Pedal, Bearing (AFCO 40292)
This pedal has a hollow splined shaft that allows you to change off-set and index arms to suit your car. The ball bearings provide smooth, bind free travel for total throttle control.
Add to cartQuick View -
Add to cartQuick View
Bumper, Coupler
This coupler is designed to bolt onto the end of the Medieval/Devilbiss chassis. Allows the ability to trim the our front bumpers to get that perfect fit to the nose cone.
Sized for 1-3/4″ OD bumper tube.
(Sold in Pairs)
Add to cartQuick View -
Add to cartQuick View
Shifter – 2– Lever
6061 Aluminum 2 lever shifter specifically designed for circle track racers!
Ergonomic and ultra lightweight open levers with correct spacing to allow easy shifting. The mount is designed as a multi piece configuration to allow for easy shifter hole cutting in your tunnel. The design also makes it much easier to assemble and install into the car without losing any parts.
Shift rod holes are 5/16 diameter and spaced ½” apart to give perfect alignment with shift rod and transmission.
Anodized a “dry slick” black for a sleek appearance.
Add to cartQuick View -
Add to cartQuick View
QUICKCAR, Master Disconnect Switch
This QuickCar Battery Master Disconnect Switch comes with a checkered flag square mounting Panel that measures 2-1/2”x2-1/2”
Add to cartQuick View
Reviews
There are no reviews yet.