- Description
Description
Lower swingarm suspension link designed to give maximum forward drive!
Precision 5/8″ rod end on BOTH ends.
16″ nominal length center to center.
Single hole plate with clearance for increased drop out angles.
Use on Midwest Modifieds and Late Models
You may also like…
-
Add to cartQuick View
SWINGARM – MOD (5/8″) – 15″ (MAXIMUM)
Lower swingarm suspension link designed to give maximum forward drive!
Add to cartQuick View -
Add to cartQuick View
SWINGARM – MOD (5/8″) – 13″ (MAXIMUM)
Lower swingarm suspension link designed to give maximum forward drive!
Add to cartQuick View
Related Products
-
Add to cartQuick View
Cup, Spring – Tapered
These tapered profile spring cups are manufactured from high strength steel and are designed to minimize any stretch and bending while still being lightweight. Has a 1/4″ hole on bottom to allow bolting to your weight jack bolt.
Add to cartQuick View -
Add to cartQuick View
Bushing, “SPHERICAL” – Trailing Arm (MAXIMUM)
MAXIMUM Spherical Bushing
Sold individually
Add to cartQuick View -
Add to cartQuick View
Rear End Brace Kit (Main Bracket Only)
This is the main bracket for the “Rear End Brace Kits” (sold individually)
Add to cartQuick View -
Add to cartQuick View
Axle, 32″ GN Gun Drilled (31 Spline)
29.5″ Premium GN gun drilled axle.
Add to cartQuick View -
Add to cartQuick View
Trailing Arm, Upper – OEM Reproduction w/ “Pull” Bushing
For those of you that want the benefits of the “Pull” bushing but without the hassle of installing them.
OEM reproduction stampings with our bushings installed. Sized for use with a 1/2″ bolt. These are a bolt in ready unit.
(Sold Individually)
Add to cartQuick View -
Add to cartQuick View
Washer, Axle
Stop spending big money on rubber seals and sleeves to stop rear end grease from being pulled into the RH rear end tube. Sold as pair.
Add to cartQuick View -
Add to cartQuick View
Rear End Brace Kit – 60″
This kit is design to reinforce the rear end so that the tubes do not bend if a wheel gets wrecked.
It will also prevent the rear end from deflecting under load and changing the alignment of the rear end while braking and under gas.(USRA Legal)
Add to cartQuick View -
Add to cartQuick View
Quick Change Mount, Upper Trailing Arm – w/ “PULL” Bushings – Metric (MAXIMUM)
This bolt on upper trailing arm mount is designed to allow use of a quick change into a stock GM metric chassis. Built with corrected pinion angle and our proven “Pull” Bushings.
NOTE: If installing on a Frankland quick change, the bracket will need to be modified and reinforced to fit.
Add to cartQuick View -
Add to cartQuick View
Mount, Upper Trailing Arm – Kit (Ford 9″)
This kit includes two “Pull” bushings, two steel spools, a rectangular mount tube and side gusset bracket. Use this kit to build your own custom rear end.
Add to cartQuick View -
Add to cartQuick View
Brackets, Trailing Arm (Single Hole)
Designed for the Wissota street stocks, these trailing arm brackets have the lowest mounting hole position possible. 4.0″ from axle tube to center of hole.
(Sold as a Pair)
Add to cartQuick View